Search results

So, i'm trying to remove the speedo gear from the front wheel hub of my cb350. I have removed the screw and drift pin from the inside. I still can't get it out...what's the trick?

Looking for ideas on mounting a set of passenger pegs when rear sets are mounted in their factory location. Bike is a CB350. I've searched and searched...can't find anything. Got photos or ideas?

Well, after trolling for half the year I figure it's time to post up my progress and make a build page. Back in May I found this bike on Craigslist and bought it in non-running condition. The last registration on the plate was 1994. I got it cleaned up, lined the tank, cleaned the carbs and...

So, I bought a 1971 CB350 this summer that had been sitting since 1985. I got it running and have had mixed results with reliability. I've gotten down to the point that I was sick of the ignition system. So, out of a desire for simplicity I decided to buy the Pamco Electronic Ignition...

Picked up a tank today at Mid-Ohio Vintage Swap Meet. Here's a pick of the side panel removed and siting on my desk as I've been searching for a match. It's got to be a mid 60's Honda, but what year and model? The actual tank has the ridge down the middle and the fuel filler on the right...