Search results

So last week my friend dropped my bike trying to put it up on the center stand and ever since then it doesn't want to start. Sometime I'll turn my key and the lights will come on and I'll kick it over and then it will power off after a few minutes. Sometimes when I turn the key the power won't...

I have a 1972 CB350 twin. It was running perfect until this morning. Now it's idling a little bit below 1000 RPMS and then eventually it just dies as soon as I go into neutral or stop at a light unless I blip the the throttle. Clueless as to what is happening. Just recently had the carbs...

one of the four nuts on the rear sprocket of my CB350 is seized. When trying to remove it to put on my new sprocket I stripped the nut pretty bad. Anybody have any good ideas on how to removed the stripped nut. I'm thinking about using a dremel to remove it. Anybody else done this?

It's a real pain in the ass and I'm totally lost. Can anyone offer any insight on how to remove it? Thanks

Can anyone tell me what size socket I need to remove the nut on the left hand side of the rear wheel on a '72 CB350?

I'm trying to replace all the old, corroded fuel lines on my lil' CB350. I've replaced the two that go from the petcock to the carbs. Does anyone know if the fuel line that runs underneath the gas tank is the same size diameter as the two from the petcock?? Thanks, Austin

Does anyone know what kind of exhaust clamp I would need for the Emgo Shorties? They would be going on a pair of CL350 pipes.

I would like to remove the turn signals on my CB350 and was wondering what the best way to do it is. Is it as simple as cutting the wire or do I need to cut and insulate/cap the wire. Any help is appreciated. Thanks!

So I have a '72 CB350 and yesterday I was cleaning and degreasing the bike. There is a mystery hose that runs down the front, under the engine and then through the swingarm. It was covered in viscous brown sludge. I sprayed the sludge with simple green and the hose literally fell apart. I guess...

Does anybody know of a good step by step tutorial on how to replace the drive chain and front and rear sprocket? Tried searching but couldn't find anything. Any help is appreciated. Thanks!

Has anyone else done this? Can anyone recommend good mufflers to put on the CL350 pipes?

Previously posted this int the wrong forum. Figured I'd have a better chance posting it here: I know this has been asked to death but I couldn't find a definite answer. Everyone seemed to be responding with what they're running regardless of whether or not it was correct. Is the stock tire size...