Search results

Happen to have an upper triple tree that'll fit a CB360?

And time flies! Threw the tank, swingarm, and tire back on to test out the gorilla glue on the diaphragms And then it sat and sat and sat, till today. I threw some gas in it and the charger, then kicked, nothing. Kicked it again with a little throttle, it fires. Kicked it one more time with...

It runs! It started and ran today!

I will ship. ;) ;D

Dallas, Texas. Also would trade for needed parts, Holley 750 w/vac secondaries, Oldsmobile 350 HEI dist, set of new 14" tires 215/60/14....

*Update* It does run! Started it today 8/15/10! 1974 CB360G, 5500 original miles, purchased from original owner's grandson. Spent a lot of time sitting in a barn, new rear tire, spare set of carbs with bad diaphragms, one's on bike have been repaired with gorilla glue, tank has been cleaned...

Not a lot of progress, just some cuttin' n grindin' Did purchase the tubing to stretch the swingarm and for the rear frame if I decide to re-work it.

In need of a pair of slides with good diaphragms for my CB360G before I start looking for a carb swap solution.

For now I'm going to try to gorilla glue the small tears I have while I look for some replacement slides or a budget carb swap, there is no way I'm spending $350 for a bolt on carb swap. After some more choppin' I have to figure out a way to keep it this low.

More cutting and sitting in the garage making motorcycle noises means the plans are leaning towards at least a 6" rigid stretch. I just havent found a 360 bobber that trips my trigger. :-\ I may actually get time this weekend to pull the swingarm and stretch it for the hardtail mock-up. I...

A little more cleaning, removal of shocks, and drop the tubes through the trees.....I think this height will work. Off to get some tubing and the welder.....

Love where it's heading but.......I was thinking along the same lines with the swingarm and ride height, now you have inspired me to go rigid. ;D

I really despise ebay/paypal but I guess it's the classifieds or that. I've been watching craigslist for parts bikes, is there any other Honda's using similar slides other than the 360/350cc bikes?

Bad news today, both slide diaphrams are torn. >:( After looking at Western Hills Honda they are $100 each, anywhere to get them cheaper?

LOVE the tank. 8)

Initially it was headed towards a Brat build but I changed to a chopper style. To start it off I'm going with a stretched swingarm, maybe 5", sporty tank in metal flake paint, raised frisco style pegs, and mini apes. There will be some frame chopping in back, probably a dropped seat area if I...

So after a string of bought bikes and one scratch build I decided on a cheap but fun build. For the grand sum of $450 I picked up this one owner, 5500 mile barn bike that used to run about a year ago First thing was to tear down the carbs and remove all the varnish. Gasket kits are on order...

Actually had a week or so but 5500 one owner miles. Doesnt run though. :'(

You know I'd looked at it both ways and it did make slightly more sense one way. :P But to read the instructions on how to set float height the tang never comes off the needle the way they are set now, so that must mean they are set waaay wrong from the PO?