Search results

Think of the cheap one as a jig so you could get the angle of the dangle just right. Nice work on the new one.

I wish i would have known about the wheel before i bought a spare set last month. Im pretty set right now and dont need any parts, maybe a gastank. I think you guys are eastcoast/midewest? I'm out in Seattle. shipping probably is expensive.

first track day was a reasonable success other than the weather being absolutely shit. It was about 45-50 degrees most of the day with intermittent squalls coming through every 20 minutes and stiff breeze ensured I was soaked and freezing my ass off the whole day. Rain tires were awesome in the...

I'm a tall bastard and I found the stock seat too low. I wanted to raise the seat height. But adding an inch of foam on the stock seat made it look too chunky, jacking the seat up over the body work would look weird, so I raised the bodywork to accommodate as well. I'm not sure the lines work...

You can check the ring gaps first and you may not need to remove any material. If you do need to I would get a piston ring filer. its critical to get the angle correct and doing it by hand is very difficult to do with accuracy. Also take the time to de-burr after grinding. Lots of videos on the...

think most parallel twins are 270 or 277 these days. there must be something to it otherwise the OEMs wouldn't do it.

Stock subframe - 7.5lbs New subframe -3.2 lbs

Great photo!

looking awesome. summer is just around the corner!

cool. i have a project coming up i may try that out for.

Nice. how fuel resistant is the TPU?

The Ridge - Shelton WA

thank you. first track day is May 6 - gotta button this up!

turned a block off plug for the fuel sensor - always fun to single point thread.

Looks awesome

Battery seems to be OK, i think maybe the battery charger wasn't charging for some reason. Harness is all finished up and everything is painted black. I made an extra plate to try and keep the plugs in tighter and organized but i'm not really happy with it so i might remake it. Went to fire...

Its all wired up. I used knock-off Deutsch connectors so everything is water tight down here. Still need to make it neat and tidy but it runs and everything seams to work - except the battery. Brand new Shorai LFX-14. Battery was having trouble turning the engine over, charged it up seemed to...

That was my inclination. I also have some drops on hand. Thanks for the reply

Yes the inner race. In this application it is removable and spans two bearings