Search results

Just wondering if anyone has had luck with stock rear sets off of any newer bikes on the older cl or cb 350 models... any advice will be greatly appreciated.

Assembled engine and used lots of assembly lube and the engine moved freely after back together.... with the engine installed on the bike I tried to put the starter back on and the engine was very difficult to turn over.... now cant get it to budge... any suggestions... I havent touched the...

Is it impossible to find a standard piston size new... How come all of the oversized kits are cheap and available but the original size is two hundred dollars. Does anyone know a good source to find the original size 65mm piston size. Is it possible to use other pistons this size with the same...

I just pulled my carbs apart once again and I noticed things this time around that I didnt before ... for instance the first thing ill tackle is if you look at this image on google it has a port marked slow jet and I noticed on my bike theres some sort of rubber plug here is this normal...

Hey I have a CL350 project engine I am going to start reassembling very soon and the engine did not come with carbs ... I know the engine I have on my bike right now has the Keihin carbs but I know A lot of people seem to like the mikuni carbs how would I go about choosing a old mikuni carb at a...

Bike is warm and I even pulled the clutch in about twenty times to warm up the clutch... adjusted the clutch lever according to shop manual but free play isnt really set correctly. Can roll the bike into first and ride thereafter but clutch lever doesnt do anything even got it into second gear...