Search results

1 & 1/2 stall garage attached to the house. Been working out of it for 12 years now. Got big plans to build another building cause I don't have room for customers bike's , quads and sleds.

Well I was close!! :o

Oh I know but cant ride during the winter unless I put a ice picks in the tires!! Thats the longest it ever sat but most of the time during the winter it sits around 4 months.

I buy plugs but the box's But I have a Repair shop and go threw allot of them. If your plugs are sooted up change them out and get it tune in.

I store my 68 Triumph Bobber for a stretch of 6 months at a time over the winter. Yes put Stbil in the tank and fill it to the top and ride the bike to get it into the float bowls. I also put the bike on a lift to get the tires off the ground. As for oil. Leave it alone. Oil take a very long...

Reg/Rec went bad. Check the voltage to the battery. With the battery at full charge start the bike and get a voltage reading then rev the bike. It should not go over 13.8 to 14 volt. If it does then you regulator/Rector fire took a shit.

Did you do a valve job on the head? Valve guides are going south. If the crankcase was over filled it would just pump it out threw the crankcase vent.

I would do a slammed and chopped Rat truck but that's just my taste. Give us a update!

If you want it to be relieable for years to come. Do the top end rebuild.

Yes Tim is correct!! If it runs better when the chock is on then you need to do a carb cleaning on all the carbs. Pull the jets and make sure all passage's are clean and not plugged. It would be best to get new rebuild kits instead of trying to get buy with old gaskets, jets and such. Also synce...

If its a 72 and sold in 74 it's titled as a 72.

Conneaut Lake Area here.

Did you make it there? I know Tom real well and I had a break down when I was down there for Mountainfest and could not make the vintage ride. Just wondering how it turned out?

I have been going to Mountainfest every year sence it started. I also go the OVBSAOC every year so I any of you that show up look me up. I do some vending and my Ford Exsplorer has a sign on it that say G&B Lawncare Service. Hope to meet someone from the forum. What are you working on? I have a...

I used one of these on a race bike I built a couple years ago. http://www.ebay.com/itm/BIKE-IT-UNIVERSAL-KILL-SWITCH-MOTORCYCLE-ENGINE-CUT-OFF-MOUNTED-ON-OFF-SWITCH-/400503022119?pt=UK_Motorcycle_Parts&hash=item5d3fd72227

Sounds like to me that your clutch plates are hanging up and not fully separating. But what am I to now just a guess!

This link may help. I'm not sure if it contains to motorcycles but it says antique motor vehicles. Here in Pa they only say you need to have 1 mirror on the left side. But if it came stock with turn signals it must have them. We are also sapose to have a head light that is on at all time's but...

Re: KZ400S Cafe Build - first try at this Like the way your going with it but the muffler doesn't look right to me. Keep up the good work.

I have a friend that lives in Pittsburgh that has a 6x10 enclosed for 1K. I now you can get 2 baggers in it if you angel them.

Probably not putting the thrust washer on both sides before putting it on the shaft.