Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Ahoy..
I'm doing a top end rebuild on my trusty '69 CB350 after I stripped one of the spark plug holes (repaired with time-serts)..
After spending countless hours carefully scraping off old gaskets, my question is, is it dumb to put assembly lube on gaskets when re-assembling. Smart idea or...
Hi y'all.
I'm currently disassembling my engine to remove it, rip off the top end and to retap a cross-threaded spark plug thread (yes I know, stupid, but I've learned a good lesson)
I'm fairly familiar with the bike, having taken it apart before (but a few years ago)... However, when I was...
Hi Tonners.
You've all be so invaluvable to me in the past when I've come across a problem that I simply cannot figure out. Well, I've got another...
My bike is a lovely 1969 CB350. She runs good, recently put on new Mikuni's and have a great spring and early summer throughout the countryside...
Hi all.
I'm sitting here with the black and white clymers manual staring at the electrical page.
I've got a fused USB port that works well when connected directly to my battery, but I'd like to connect this to my ignition to prevent any discharging (still haven't found the final word on if a...
Seeking advice...
Hi all. I have a lovely 1969 CB350 that I rebuilt and have ridden almost daily for the past five years. However, I've been having carb issues with the stock Keihins so dropped down for a Mikuni VM30 kit.
I spent many hours trying to get them working as they came fitted, but...
Hi all. I searched around and haven't not found a difinitive answer on this one. Would really appreciate any tips.
THE SIMPLE QUESTION:
Does it matter where on the fuel line you place an in-line fuel filter. Should it, for example, be below the level of the float bowls, or lower point, or...
Hi all,
Could use some more helpful advice from the forum who already got me very far.
As of late, I've been experiencing a cold exhaust (right side) and popping when throttling up. Left appears to run great.
I'm getting a good spark.
The points are adjusted.
I cleaned the carbs (jet size and...
Hi everyone. I know there are a few threads here on people having similar issues, but I've tried the suggestions and not having much luck. Over the winter I did a complete engine overhaul. Now, the bike has been reassembled, turns over and idles and runs fine.
The Problem.
The clutch is not...
Hi again everyone.
Could use some more advice for my fixes of my 1969 CB350K0.
So, I'm green to this but getting my hands dirty and trying to do as much as I can between myself, Clymers and this forum. I've recently discovered the problem with my kick-start, and could use some advice, tips on...
Hi all.
I'm have an 1969 CB350 I'm fixing up and modifying a bit over the winter. One is the kickstart spring which must be snapped. I've removed all 10 screws surrounding the crankshaft cover, but it's not budging. Is this just stuck, or are there any connections elsewhere or within that I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.