Search results

http://www.ebay.com/itm/New-Blind-Hole-5pcs-Slide-Hammer-Pilot-Bearing-Gear-Puller-Removel-Kit-/400438475644?pt=Motors_Automotive_Tools&hash=item5d3bfe3b7c&vxp=mtr I have one of these kits, if the inner diameter of the bearing is close to the collet size then it works well. I had to use propane...

Hi.. just found the Aus sub-forum thought I'd check in! I am from Brisbane and currently working on this CB150 bucket racer: The bike ran when I got it and is an ex-bucket racer (last used 15+ years ago). I stripped it down with the intention of cleaning/painting/restoring and adding new...

I have a CB125 (bored to 150) engine that I partially disassembled to clean & paint. Bike is intended for race use only and has been used in the past as a bucket racer before I bought it. I removed the stator/gen, cam chain and tensioner initially. Now putting the cam chain tensioner back...

Not sure what the rules are on posting links to other forums but from a quick google this should provide a bit more relevant info for OP: http://cx500forum.com/index.php?/topic/8687-83-cx650-custom-starter-clutch-issues/

Assuming this is a starter clutch.. skip to 2 minutes: http://www.youtube.com/watch?v=N7xWAdoQOI0 My GS1000 only has 3 rollers and springs, I picked up a set of replacement rolllers and springs for about $30. I would assume the rollers are a softer material so that they wear down rather than...

Hi :) I recently picked up an ex bucket racer which is a bit of a mix and match of parts.. in many searches since I have come accross DTT more than a few times and found plenty of awesome builds and some excellent info so I thought I'd share what I am doing on here! I have been riding on road...