Search results

Any Side covers ?

I have a 78 Maroon SR500E unmolested, shows no signs of every being layed down, 25K showing on the meter. I purchased this from the original owner, comes with the original owners manual. Check out the pictures and let me know if you are serious. Will consider trades of Honda NS50F, Yamaha...

The following came out of Machinist's Workshop magazine , and was given to me by a Gunsmith friend No Oli Use........................ 516 pounds torque WD040..............................238 pounds torque PB Blaster..........................214 pounds torque Liquid...

Im In Washingotn State and would like to trade for some other state plates, or buy, Thanks for your time

Ill do it this way, couldnt get it to pick up other pics.

Here are two of my small modifieds, many more to build yet

I need the left side knee pad for a 69 CL70. will buy or trade for ? Thanks for your time

Looking for both right and left side covers for a 1971 SL100, Let me know general condition and picture if possible. Thanks Jerry

Mosta of the bike is gone, I still have the engine, front & rear wheels, front forks and complete headlite.

I have every thing with exception of the caliper, forks do have pitting under the boot covers, every thing else is good, front wheel has a new tire on it. In Spoakne

Yeah now there are three, ive been looking and finally went out on a limb and ordered a set from the Far East. I will let you know about the fit and quality when they get here. Ive had mixed luck in the past with quality and fit.

Some where I stumbled onto a post of a person rebuilding a 125 ( maybe a 100 ) Honda with pictures and text, very complete and helpful. Can anyone direct me back to that site or post ?

Do you know where the Tank Came from ?

I hope I have replied to every one here on the 350 parts, if not please contact me again and I will pick up the loose ends.

Send me your e-mail and i will get pics back to you of the forks and a guess on shipping. Jerry

The tank is gone, Forks are straight and clean, $75.00 plus shipping from Spokane 99202.

I have a set off a 73 CB350, slides are free and they appear to be in good working order, Based on the rest of the bike which has 14K miles on it and the tank showed some paint rub on the right side, let me know and I will get some pictures for you,

I have three manuals 1st one is a true Honda Shop Manual for CB250-CL250, CB350 & CL350 printed 1971. Cover and all pages still intact, some lite water staining on edges ( probably coffee or Beer) every page has pictures or diagrams. $35.00 plus shipping.2nd choice is a Clymer Service Manual...

Fork boots are cracked, would rather sell engine complete,

It appeared to be stainless, gloss finish but when I cleaned it up the under side showed a yellow or gold tinge.