Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
i am running handle bars that are not drilled to run the wires inside. is there a best way to run them outside. do most people just drill a hole in the control housing to get the wires outside? thanks in advance for your help.
Yup I had to modify the control housings to get them to fit on my clip ons (cb360). I used a dremel to cut away enough of the housing, on the inside of the lower half. It might take a while to get it just right so that the housings "cinch" up nicely. The left side one is the tricky one because of the wire routing.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.