TijmenK
Been Around the Block
Montag said:I'll measure the loop and give you that info later. As you can see, it wasn't a single piece. I needed to bend 2 curves and weld them.
(...)
I can take a picture of the wiring, but it won't be very elucidative (it's messy!).
I used the original wiring diagram to simplify mine.
(...)
It was very easy. All I needed was a multimeter.
Thanks man, I know a dude with a bender, but that one has a minimum bending radius of 300mm, I'm assuming it needs to be smaller than that, but not sure. And thanks for the wiring diagram, I have a Haynes manual underway, but always good to have a spare.