Recent content by wcwmoto360

  1. W

    Junkyard 74 CL360 Resurrection

    Re: 74 CL360 Resurrection to Cafe Racer Update! Motor teardown. No more surprises, yet! Fingers crossed as I proceed.
  2. W

    Junkyard 74 CL360 Resurrection

    Re: 74 CL360 Resurrection to Cafe Racer fresh_c: ya the patina is cool, however there is nothing on it that can be used by just cleaning her up. The tanks, well there's preatty much no bottom on it and I don't think a tank coating kit will seal all that. But thanks for your comment. kosmot...
  3. W

    74 CB360 Syntriphical Oil Filter Housing Removal

    The boiling water might have worked had I not already stripped it out. I couldn't tell you if someone replaced this part with an older one at some point in time, very possible. I'm looking at installing an external oil cooller, filter, pump setup so I don't have to get into the case everytime I...
  4. W

    looking for a 74 cb360 shop manual parts interchange

    fielder.casey Did you ever find your shop manual PDF for the 360? I could use one or if you point me in another direction. Thanks, Ride Safe!
  5. W

    Junkyard 74 CL360 Resurrection

    New to the community with a first time total rebuild. The platform that I am working with is a Junk Yard find 74 CL360 I picked up for $100 bucks. It still had a 1976 license plate with a 81 registration sticker on it. I'm assuming it has been sitting since 81 or 82 so that's 32-33 years...
  6. W

    74 CB360 Syntriphical Oil Filter Housing Removal

    I sure did remove the clip. I was surprised too, since all the threads I read made it sound like it should just pop out of the housing. It didn't and the steel bolt stripped the aluminum threads. But the re-threading and the massaging that I did as stated previously worked nicely.
  7. W

    74 CB360 Syntriphical Oil Filter Housing Removal

    Re: 74 CB360 Centrifugal Oil Filter Housing Removal Heading corrected, i have moments like that with words i rarely use. Well I did bottom the bolt out and stripped the threads on the cap. And the cap didn't come out. :( However, I regrouped, drilled out the threads, threaded to 8mm x 1.25...
  8. W

    74 CB360 Syntriphical Oil Filter Housing Removal

    I had read a few thread about this and tried what was suggested with no luck. Just to recap, I removed the expansion ring clip and threaded a 6mm x 3" bolt into the center of the housing and bottomed it out on the shaft. Then I wrapped on the house with my rubber mallet and then began tightning...
Back
Top Bottom