Search results

Update on project; Picked aluminum diamond plate for electrical panel Breather filter gas tank seal And ………………………………………………………… $100 1977 CB 360T

I’m using original wire harness and will run couple extra - /ground wires to the frame, engine and front end. Thanks, deepwaterimports Idea was to balance black and chrome/aluminum.

PJ you are absolutely correct, spacers were swapped side to side. Thank you, Seeking Zero. Currently I’m working on electrical and gage cluster photos will follow shortly,

Thanks axeugene27, Fender was only connected to frame by OEM fender hanger, in front and plastic cup on tire as spacer (temporary install). I like the look and have same concerns if tire will hit fender in drive. I had painter do my paint; Black (frame, wheels, …) powder coated total $400 by...

Thanks Sonreir, Yes, fender was off center due temporary install to see if the tail light/plate bracket would work/look fine.

Project update; Installed clip-ons and learned that there is no room to adjust brake master cylinder for comfortable front brake lever position. Not sure about rear fender; Front end;

Thank you crazypj, Advancer plate assembly was removed cleaned and lubricated; installed new contact breaker points and adjusted to 0.35mm; checked timing marks “LF” and “F” for points opening. I’ll follow with timing when I start the engine. I did check 'full bump' clearance per photo below...

Thank you 3DogNate, will do. OJ, I didn’t polish engine, a bit cleaned. I’m not sure yet of polishing or powder coating. Update on project;

axeugene27, “Do it right” is way to go Don’t forget to do what makes you happy too! Sorry Sonreir, next project I’ll check with you first.

Yes, search on ebay “POLISHED ENGINE STAINLESS BOLT KIT” This is kit for CB/CL 360 that I have; http://www.ebay.com/itm/HONDA-CB360-CL360-POLISHED-ENGINE-STAINLESS-BOLT-KIT-/261043223473 This is same sealer with different kits; http://stores.ebay.com/stainlesscycle

Thank you, 3DonNate I checked your project, nice quality work! Sonreir, vinyl stickers are my favourite ;) (I hope they are made by you, purchase was made in November on ebuy Dave R.)

Very impressive bike project and journey, and man you can write too!

Re: '74 CB360 cafe project (de-funking stage) Nice bike, I’m on fence polished or powder coated engine covers. Polished is preferred, a lot of work that comes with polishing is not.

Project progress; More parts arrived;

Project update;

I drilled rivets out; subsequently I was told by painter that plate is ok to stay on frame.

Re: 74 CB360 "True North 360°" Powder coated frame and parts; New bushings

Re: 74 CB360 "True North 360°" And more parts; Ultrasonic Cleaned Carburetors;

Re: 74 CB360 "True North 360°" Thank you and welcome to the club OJ! Congratulations on your new purchase. ;)... ::)

Re: 1975 True North 360 Thank you Sonreir, Congrats on your build, nice project! Re carbs; That is what I did ;) No carbs