1971 cb450 starts but wont stay on !

HONCB450K4

New Member
8) I have a 1971 honda cb450 -

recently replaced the points and did the timing.
i replaced the regulator/rectifier and starter solenoid.
it has new battery.

i pulled the spark plugs the left one is running rich plug is black the right one is lean plug was a bit brown.

carbs were cleaned but wasn't really paying attention to jets just around bowls.

my issue is with new battery and all i can get the bike to start up but then it dies after a few seconds after a few tries the slectric button wont work because battery will be drained.

but able to kick start.

do i have a bad ground somewhere? AND a bad carburetor TUNE?

any advice?
 
Was it running prior to the work?

Carbs need to be so clean you would not be scared to eat or drink from them. Make sure the slides are not stuck and the jets and passages are clean. Make sure the throttle valves are synced.

Did you static time it or just set the gap? How are your advancer springs? Do they pull the weights back tight against the cam or are they loose?

450's run off the battery at idle, a dead battery will cause really crappy running. Shouldn't take more than a few seconds on estart COLD to start to start a well tuned bike but you should be able to run the starter for several 20 second runs with a minute or so cool time in between.
 
I had the bike running perfect before G/F let it sit for about two years. top end has always been noisy but ran great.

the tank recently flash rusted and i cleaned it out and replaced the gas cap gasket and pet cock its all clean and good now.
i cleaned the carbs.

i did the timing myself with a Test light followed instructions on you tube videos. on timing cb450's..
pretty straight forward and easy. got her to open up right on the marks.

the spring on them are good they pull back well.
 
Just removed the carbs to clean . Wasn't getting gas on ON position only on RESERVE. Does it matter what peacock connection connect to which carburetor or no? Also is this a bad pet cock or did I install wrong? Only works on reserve....
 
It was plugged. Removed now working properly getting fuel from both.

So I also cleaned up the carbs and upon reinstall the throttle blades are not seated all the way is this normal!?

I loosen the nut but still not seated all the way they are a little less the half way open.
 
I got the bike running but now something is up with my throttle cable it's not returning the throttle blades to fully closed not sure what I f%#^* up need help asap! Thanks .
 
It was stuck about half way with black electrical tape. ! I got her turning on and stay in on.

Now next issue!

Key on, choke on, switch on position, gas on, START.

It starts but as soon as I turn off the choke it idles really high maybe 4500 - 5500 rpm what do I look at next?
 
Choke on makes a rich mixture that the engine can burn easily when its cold. Once its warmed up it doesn't need it and will attempt to flood out/foul plugs.

Idling at 5000 is probably due to carbs that are out of tune. Either your idle is set too high or they are out of sync. Or could be timing advance unit is stuck at full advance.
 
I lowered the idle screws out all the way I also closed out the throttle cable screws all the way in to close the blade fully. It starts right up with choke on once off it goes up to 3k rpm and it dies off.

I did just notice no vacuum coming from left carb.
And what seems like normal vacuum coming from right carb. What could cause bad vacuum/suction from left carb?
 
Pulled the left spark plug spark seems good and it turns on with it off.

Pulled the right spark plug and it won't star with it off... Sparked good though.

Maybe a condenser issue? Would a condenser cause no suction from left carb though?
 
Update - I was messing with the throttle cable adjuster screw and I opened it almost all the way and got suction from left carb . After turning off choke it does not idle high anymore but it does still shut off....

Also there is a hose located on top side of motor on carb side dead center this hose is long and when on it leaks a good amount of oil... Shoul I block this off or do I have a bad motor or gasket somewhere?
 
Is this common? Right side throttle cable screw it lost all the way in where the left side throttle cable is almost all the way out. And that seems to make the idle happy.... :o
 
Oil drained and adding new oil today - advice on how many quarts a 1971 cb450 takes?

okay guys so i did the points and the timing - and i did a BENCH sync on the carbs.

i got it idling pretty damn good but once i take off the choke i does in fact stay at good idle but then i go to give it gas and it gets a couple good throttles but then it dies. any advise on this?
 
It holds 3 qts. I add 2 then keep adding a bit until the dipstick shows full.


end of line
 
When you say you take the choke off, you mean you turn the choke lever so it is pointing down right? Lever pointing forward is choke ON. Pointing down is OFF. I had this backward when I first got mine.


end of line
 
Back
Top Bottom