1981 CB750F Super Sport Carb jetting advice wanted.

weenz0r

New Member
Hello everyone, I'm in the process of fixing up a 1981 CB750, I have cleaned the carbs and waiting on my rebuild kits to come in so I can reassemble. It had stock jet sizes in it. I have Pod filters to install and the bike has an exhaust (header and muffler). It is Muffled if that makes a difference. I'm looking for advice on what size jets to start off with. I was thinking of going with a 40 idle jet and a 110 main jet. What are your thoughts? Thanks for any help!
 
The general consensus on the jets in a kit are that they are garbage. Best bet is to buy genuine. The aftermarket jets may no be cut to the same tolerances as OEM and therefore may cause tuning issues or headaches. Needle tapers may be off, etc. Use the gaskets, air screws and float valve and you should be good. I know that this does not answer your question but if you are trying different jet sizes buy OEM. Good luck.
 
an 81 cb750 should have far different jets than you're listing....

they are a primary/main style jet system not similar to the earlier SOHC carbs. the stock primary is a 68 and the stock main is I think a 102 or 105.

The hard part with the DOHC carbs is the needle. The taper on them is not sufficient to deal with pods and exhaust. Dynojet makes a complete jet kit you can get on amazon for $89. the needles in them are the real part you need, but they refuse to sell just the needles (I've asked very nicely). Their kit is a stage1 & stage 3 in one kit. Stage one is stock airbox with exhaust, stage three is pods and exhaust. the kit is spot-on perfect if you follow the directions, I just did one on an '81 cb750 custom with UNI filters and a CycleX 4-1 exhaust and it runs extremely well.
 
focusinprogress said:
an 81 cb750 should have far different jets than you're listing....

they are a primary/main style jet system not similar to the earlier SOHC carbs. the stock primary is a 68 and the stock main is I think a 102 or 105.

The hard part with the DOHC carbs is the needle. The taper on them is not sufficient to deal with pods and exhaust. Dynojet makes a complete jet kit you can get on amazon for $89. the needles in them are the real part you need, but they refuse to sell just the needles (I've asked very nicely). Their kit is a stage1 & stage 3 in one kit. Stage one is stock airbox with exhaust, stage three is pods and exhaust. the kit is spot-on perfect if you follow the directions, I just did one on an '81 cb750 custom with UNI filters and a CycleX 4-1 exhaust and it runs extremely well.

Can you post a link to that stage 3 kit? I think that's what I need to get. and yes you are correct my stock yets are 68 - 102
 
http://www.amazon.com/Dynojet-Research-Intake-Performance-Kit/dp/B000GV14MQ/ref=sr_1_1?s=automotive&ie=UTF8&qid=1441287862&sr=1-1&keywords=Dynojet+Research+Intake+Performance+Kit+-+Stage+1+%26+3+1127
 
62f1dc4a7e9027b5efccaa658154534e.jpg


Sent from my SM-G900V using Tapatalk
 
Back
Top Bottom