1982 CB125S with CDI - 6V to 12V swap **Question precised

max9505672

New Member
Hi,

I've recently bought a 1982 CB125S. During the winter, I'd like to swap the 6V electrical system to a 12V system.

I found this great DIY file that explains how to do it on a 1975 CB125S (see attachement).
It's kind of long procedure so here's a quick summary for the 1975 CB125.

• Rewind the alternator stator.
• Install a 12V rectifier/regulator.
• Install a 12V Battery.
• Replace all lighting bulbs.
• Install ignition system resistors (to keep ignition coil current at ~3.3 Amp)

What I'd like to know is, since the 1975 CB125S ran on point ignition and I run on CDI ignition, is this procedure still doable on my bike? What more would it involve?

Thanks.
 

Attachments

When CDI is involved, it becomes a lot harder. Most CDI systems are fed from an independent coil on the alternator, so you need to ensure that portion of the wiring can be isolated from the rest of the system. Most CDI boxes don't require external power, but if yours does, you might be looking at a voltage regulator or resistor setup.
 
I think your 6 vt. 82' CB125S w/ it's CDi pulse generator on the cyl. head should work well w/ a 12 vt. system;I have an 81' CB125S and it's identical to your 82' except for color.
I'll be doing this same type of swap on my 81' CB125S;I'll be swapping over the entire motor and wiring harness from my 1983' XL200R which is the first year for 12 vts. in that one.I believe I'll need to include the original XL200R 12 volt ign. coil & every other single component(including the CDi box as it's different than the 6vt. CB125) including # YB3L-A battery too.I'm glad I was able to purchase the complete XL200R so I have the parts I need,easier than 'piece meal'..,I've done my share of that too. :)
 
Back
Top Bottom