74Cb360 crankcase mystery bushing

[revlow]

Doing engine work on my bike this bushing needs to be replaced. Told by Honda they don't make it anymore. Any one know where to get one.
I'm pretty new to this stuff

Sent from my HTC One_M8 using DO THE TON mobile app

 

[teazer]

That looks like the hollow dowel pin to locate the side cover. Honda used a few different size but I'd be surprised if you can't find one.
I checked on lone and it's part 94301-10140 and is available for $1.43

http://www.partzilla.com/parts/detail/honda/HP-94301-10140.html or from your local dealer.

 

[irk miller]

How did you know what he's talking about? All I see is a schematic of the clutch assembly and the side cover.

 

[ApriliaBill]

I think it's the circled piece on the diagram.....

 

[irk miller]

I think it's the circled piece on the diagram.....

Thanks. I didn't see that.

 

[jessemetsos]

yup guys like apriliabill said , I think its the one with the circle around it

edit : sorry posted at the same time that you irk miller

 

[revlow]

Hmm I guess it's not even shown on the diagram

Hope this helps, I wish it was as easy as the pin

Sent from my HTC One_M8 using DO THE TON mobile app

 

[irk miller]

Why do you think that needs replaced? That's where the cover meets the inlet to the oil filter.

 

[teazer]

I don't have a CB360 clutch cover to check. What is that and what fits in it? The parts list do not show that part. In your photo it looks almost like an isolastic bush with rubber in the middle, but that may be deceptive.

Does the oil pump drive shaft go through that by any chance?

Presumably it was loose in the outer cover. That could be a problem if the cover is worn where the bush goes. That could need the cover to be machined and a custom bush made up to press in, but the real question is what goes in there.

PM Sonreir or Trek or CrazyPJ or one of the other CB360 guys who can give you a definitive answer.

 

[irk miller]

It shouldn't need replacing. It doesn't need to be a perfect seal. It's just where the cover meets the inlet to the oil filter. The oil runs through the cover on the 360. That's just part of the return. Any oil that "misses" the filter just falls into the sump and gets pumped back up to the head. No biggie. When people modify these with an external oil filter, that gets removed altogether.

 

[revlow]

The only reason for thinking to replace was the rubber is deteriorating

Sent from my HTC One_M8 using DO THE TON mobile app