75 cb200 creating a murder scene out of oil!

skinnylegsjames

New Member
First time post, so.. Hello eveyone!

I dont normally do this but im at my wits end with this engine

A little back story, because we all love tons of reading, right?

Picked this bike up last year for parts, was crunched in the back, and since then its taken on a new life.

I recently did a full rebuild on the engine, due to lost compression last fall. Its been re-rung, port and polished exhaust ports, and freshened up in the head with new valves, springs, and seals. Few days ago I finally got my long awaited gasket kit in and put her back together. Right out the gate the engine fired up and ran almost flawless! little carb tweaks here and there and she ran perfect.

Next day I took her out for a round in the city when my points housing locked to the cam, and thats when i found out about the oil flow problem with these engines. Turns out my tach housing gasket actually was blocking the oil passage (gasket was cut wrong and only allowed for a pin size hole for oil to flow through)

Onto the next day. I sourced another housing locally, and slapped that on. Here is where the fun part comes into play. I started the bike up and instantly she revved straight 5k on the tach. Quickly shut the bike off, and i noticed oil sitting on my head right about the exhaust port. still clueless on where this oil came from. I started the bike up a few more times, and still revs straight to 5k. I toned down my mixtures on the carb to calm her down, so now she'll start and nail right at 3k on the tach. After monkeying around with trying to calm the idle down the bike instantly starts blowing oil through left bank exhaust, and i dont mean burning, i mean misting oil like a garden hose. I want to say maybe half a quart blew through the exhaust in about 30 seconds. So much oil is all over my floor its created a murder scene with my tools. As I pick them up it leaves behind nice silhouette of open end wrenchs.

The facts before their asked.

Compression 170 psi on each bank
Timing has been checked twice now, dead on
Points set to F mark (I was thinking maybe this was causing my high rev)
No oil in cylinders, right bank had a nice brown burn to the end of the plug, but left bank was nice and black(but not oil covered)

One thing to note is I noticed the right side seems to be nailing down awesome power but the left side is giving nothing unless i really bring up throttle. The bike will rev nice and straight to redline with no hesitation, even with oil raining out the exhaust. Honestly the best ive heard this thing run.

Ive searched, and searched, and searched, cant come up with any hints on why this happening, any insight would be greatly appreciated.. Im almost ready to stretch my frame and fit a 350 in her. Ive got to much back story with bike to call it quits on this old girls heart....

Pics of the old girl..
More to come if i can every get her up and running right, ill do a more proper introduction then, with fun parts worked into this frame.

tumblr_n69l6dOpW91scrxo7o1_1280.jpg

tumblr_n3kglglWyB1scrxo7o1_1280.jpg

tumblr_n30rfzkgDV1scrxo7o1_1280.jpg
 
Left cylinder blow by caused by oil starvation. Tear it back down. LH valves may be rough too
 
Back
Top Bottom