A seat question...

what about something off a newer bike ? like you see on a lot of newer sport bikes with a seat cowl that just pops on and off? i see the one in the pic is very close but do you think someone can make one work off a say SRAD GSXR ? just throwing it out there ?
 
Nice seat and nice bike you got going on. 8)


Speaking of pissing I gotta go take a quick break. :P Nice bike though.
 
Depending on what your looking for, I kept my stock seat mounts. I have my stock seat for 2-up style, and then I have a cafe seat that uses a factory seat pan. I know there are a few places that sell cafe seats on factory pans (e-bay) or maybe you could find someone with a welder and do the seatpan 1/2 tank trick (what I did)
 
Im a bit of a fan of the triumph thruxton style. Its very much like the old half gas tank shell style others have mentioned. I intended to complete the seat on mine in this style, but am going a slightly different route now. A few pics of the seat are near the end of my build thread in signature. The seat itself was stitched up by someone else but I cut if from stock pan and foam. Good luck and show us all how it goes!
 
I shaved my factory seat and it turned out pretty good and still room for passenger. I will try to upload a pic


sorry never mind the pic is too large. i will try to figure another way to post it

Sent from my ADR6400L using Tapatalk
 
Back
Top Bottom