Bike teardown tips

facefirst35

Coast to Coast
Hey all. So I bought a '70 CL175 for my girlfriend that we're gonna start tearing down tonight. My other bike is a '79 CB650 that I bought halfway into a cafe project and the parts were just all in boxes, so it wasn't too organized. I'm pretty OCD about stuff like that and want to keep it as organized as possible.

Any helpful tips, tricks or words of wisdom from you guys and gals when tearing a bike down? I'm sure plenty of you have done it enough that I can learn from your mistakes!
 
label all of the electrical connections well ( is just start with numbers or letters )
and take lots of pictures as you go, they are very helpful with the rebuild when you cannot remember where a part went or how the wires or cable routed.
 
Ziplocks in various sizes and a sharpie to write what each little group of nuts, bolts and clamps came from. Take pics of how things like the center stand spring is connected and other parts like that so when you go to re-install you can reference. PB blaster is your friend for rusty nuts and an impact driver for Shitty phillips heads. pateince with siezed things or you will break it and have to figure out how to remove the broken part. Beer also makes disassembley go much smoother, as in PB blaster to nut, drink a beer while waiting for it to work, try it, if free, move on, if not, more PB and another beer....repeat. Cheers and have fun.
 
if taking an engine apart, i get a cardboard box ( more than one? ) when you take a bolt out push it through the box in the corresponding possition so when i put it back together those bolts that are only a few mm's different length go back it the right holes.
cant describe this very well but, say the first bolt you remove is the top gight on the crank cover or case ( OR HEAD BOLTS FOR THAT MATTER) (oops must have hit caps lock) the bolt goes in the top right hand side of the box. i some times draw the shape to help especialy where ther are different rows of them.
Hope thats helped more than confused you ::)
 
agreed with everything said above. The biggest tip I can give is to take lots and lots of pictures. I did not do that and have struggled with things. in particular, take lots of pictures of the rear brake linkage, the center and side stands to show springs, etc.
I also used a bunch of ziplocks with labels on them to sort the hardware out.

The other mistake I made was to tear down two bikes at the same time and I didn't do a good job of keeping them separate. Its hard enough keeping one bike straight, let alone two bikes that are all thrown in the same boxes.
 
Back
Top Bottom