Billet Engine Breather Systems! Universal Fit! $75 DWMS Racing

[joeyputt]

We have been running these breather systems for years and run them on all of our racing engines here at DWMS Racing, after posting photos of one on my reverse port engine I started receiving requests to offer the system as a package so here they are!

Single breather line can with fittings, filter, and drain $75

Dual breather line can with fittings, filter, and drain, $95

We have rubber or braided stainless hose available as well.

$5 shipping to the continental United States.

This engine breather solves the problem that is created when removing the stock air box and running filters or velocity stacks directly on the carburetors on most motorcycles, atv's, dirt bikes, karts, etc. Factory engine breather tubes are connected into the factory air box so that the crankcase air is filtered however when we all remove the stock airbox this leaves no where for the breather tube to be properly connected to filter the crancase air. The engine breather tube normally passes a small amount of oil as well so simply attaching a filter to the hose normally causes oil to drip from the filter. This breather system utilizes a billet aluminum can to catch the oil and comes complete with a petcock drain for easy periodic draining of the can without having to remove the breather system as well as two large clamps to mount the breather can to your chassis.

Measurements - The breather system is roughly seven and a half inches long with a round top style filter and seven and three quarter inches long with a square top style filter, all of the filters are roughly two and a half inches wide at the base.

NOTE - This is a universal engine breather system that is intended for off road use only on a variety of engines and as the sizes of breather hose fittings vary greatly from one engine to another it may be necessary to replace, or add an adapter to, your original breather hose fitting for proper hose fitment.

I have these systems in stock now and they are ready to ship!

We accept Paypal!

All of the fittings are the same size thread so that they can be changed to run the breather system standing or sideways as seen in this photo.

 

[joeyputt]

Re: Billet Engine Breather Systems! Universal Fit! DWMS Racing

Here are a couple photos of our dual line breather system on my reverse port engine.

 

[Tim]

Re: Billet Engine Breather Systems! Universal Fit! DWMS Racing

Holy crap that's nice. I think I need a dual line setup on my XS650. Have to see where I'd fit one first though.

 

[joeyputt]

Re: Billet Engine Breather Systems! Universal Fit! DWMS Racing

We will also custom build these breathers to order with custom size fittings and other styles of filters!

Brother Tim here is yours!

 

[joeyputt]

Brothers I know several of you have these breather systems, I have a few left in stock before I put the next batch of them togethor if anyone else would like to have one.

I am also now offering the system with your choice of the original style filter or a k&n style filter.