Carb Gasket Won't Scrape Off - Critical or Not?

1sttimer

Over 1,000 Posts
I'm having some serious trouble getting the black fiber gasket off of my intake manifold where the carbs attach to the head of my cb175. I'm not talking about the spacer, but the actual gasket itself.

I have tried everything. My question is simply what does this gasket do besides keep airflow from escaping at the junction of the carb insulator and head? I know the spacer acts as a heat sink but is it necessary to get this gasket surface on the head as clean as I would a head gasket surface?

I feel like I'm going to have to score the surface a bit to get the gasket remains off and I'm afraid of the result if I do this.

Thoughts??
 
Soften the old gasket. Nail polish remover against the aluminum, plain old water on the carburetor boot. Let it soak, it will soften up and come off with a scotch brite pad.
 
I've tried acetone, purple power, brake cleaner...nothing. Razor blade took a little bit off but the majority is stuck on pretty bad. Does anyone know what this thing is made of so maybe I can look up something that would degrade it?

Or should I even worry about it at all?
 
Try a small angle grinder with a scouring pad like these http://toolmonger.com/2008/04/04/3ms-roloc-surface-finishing-kit/ . It shouldn't mess up the surface I've used these to get off old water pump gaskets and have never had any problems.
 
+1.
Another option is the plastic (nylon?) finger wheels by the same company. They're just as good, but take a little longer to do the same work. The big plus is, they won't scratch the aluminium.

You need to get all that paper nastiness off, or else you'll end up with air leaks after the manifold, causing all kinds of running issues.
 
Can you provide me a link for these 'finger wheels' you are talking about? I'm not sure what they are and google isn't helping me out. Thanks!
 
Check out your local Harbor Freight, they've got everything you need. http://www.harborfreight.com/2-inch-80-grit-shaft-mounted-cup-brush-91367.html
 
Hey misfit, that link was 404'd. I'd definitely check out HF for them though. The ones I use are made by 3M and/or Wurth. I found the 3M page for them, here

http://www.3m.com/product/information/Roloc-Bristle-Disc.html

Apparently, they are actually called "bristhe discs". They go on the same Roloc hub that misfit's cookies go on.
 
^^^^ This thing. You can get them at O'Reilly auto stores for sure. I think they have 'em behind the counter, so you'll have to ask. Bring a picture if you can - they might not know what you're talking about. Kinda pricey, but you toss 'em on the end of your angle grinder and they'll make short work of stuck gaskets and won't mar the surface below. You can get the correct arbor at Harbor Freight in this kit:

http://www.harborfreight.com/complete-sanding-disc-kit-43029.html

BUT DO NOT USE THE HF PADS ON ANY MATING SURFACE. THEY WILL SCRATCH IT.
 
+1 Get the "yellow" ones since they are made for aluminum (if 3M brand...not sure about HF brands) Green is too gritty and made for steel. I'll see if I can scrounge up a picture. I just toss it on a drill and it "looks" like it's scratching the aluminum...but when you get all that crappy old gasket off, and clean it up, it's just fine! I stopped the first time I used them, and had to make sure I wasn't doing worse damage :o ??? ::)
 
Back
Top Bottom