Finnigan
Over 1,000 Posts
Putting in my vm30s
Got the universal cable from DCC, measured the cables, soldered on ends and before I measured the other end I couldnt position the cable couple housing anywhere on my frame that didn't make one or both carbs come out of sync.
The only position they operate correctly when I pull the single end is holding it strait up, whenever I lay it on the frame and then pull it sticks/one jams open etc.
What am I doing wrong?
Got the universal cable from DCC, measured the cables, soldered on ends and before I measured the other end I couldnt position the cable couple housing anywhere on my frame that didn't make one or both carbs come out of sync.
The only position they operate correctly when I pull the single end is holding it strait up, whenever I lay it on the frame and then pull it sticks/one jams open etc.
What am I doing wrong?