CB 350G Wiring New Control Switches and Mini Speedo

nestcraft

New Member
Hello Everyone,
This is my first time posting, been a long time reader.

I have a 1973 CB350 G that I have been fiddling with over the last year and I finally decided to bite the bullet and upgrade the worn control switches and bring the electrical / charging system up to date in the hopes I will have a more modern and reliable bike in the end.

SOOOO, I have a table full of new parts... new handlebar control switches, new mini speedo (with indicators), new headlight, new tail light, new smaller turning signals and then a new electronic ignition, stator, regulator and rectifier on the way.

I am new to the motorcycle wiring world and it all basically fries my brain a bit to even think about the entire wiring schematic at one time. I do have the original wiring diagram and it all seems to make sense when I look at it but my issue is this.... none of the new controls or speedo (with indicators) are OEM for the bike, so this is far from a plug and play situation.

Would I be better off to strip all the wiring harness off the bike and start from scratch with my own? Would doing this create fewer problems in the end? Is this too much for a novice to do? Any help would be greatly appreciated! I stomach is turning a bit with the feeling of "what have I gotten myself into!"
 
If it's just the speedo and hand controls, I'd leave the harness alone. Unless there's some other reason you're wanting to replace it?
 
Back
Top Bottom