CB/CL 350 owners, I need your help.

[alzcbz]

I am trying to reverse engineer the rear of my CL350 frame. PO was in the middle of a hardtail conversion. I am trying to go back to stock geometry.
This is what I started with:

Here is where I'm at:


I would really appreciate if someone could give measurements from swingarm pivot to upper shock mount and rear tank mount to upper shock mount.
What is stock length on shocks, center of eye to center of clevis?
A photo from above the rear frame would help too. So I could get an idea of the shape of the upper frame rails.
Thanks in advance for anyone's help.

I posted this in the Suspension section but there is more traffic over here.

 

[cavity.]

PM'd you. I'd like to buy the hardtail (or possible trade)

Swing arm pivot to upper shock mount: 17.5 in
Back of tank mount to upper shock mount: 14.25 in
Shocks center-center: 12.5 in


Note that the rear fender mounts been removed