CB200 Frame, Wheels, Motor

S

SullivanCB200

Been Around the Block
Still have this stuff in my parents garage. They want it out. Please, make me offers. I have a nice straight 1975 CB200 frame, front forks and rear shocks, both wheels, and a complete motor minus camshaft and pistons (disassembled mess). Condition is not great, not terrible.

Thanks,
Andy
 
The wheels could be cleaned up very well. I think there is one small spot of pitting otherwise there was just a hair of superficial surface rust. The area underneath the rubber lining (goes under the tubes) part was pretty rusty but nothing damaging. The spokes are all in decent shape, but again did have some rust here and there. I'll have to just send you pictures so shoot me your email.

As for the title, short answer is no I don't have the title. Its VERY easy to obtain one in TN for a bike this old, but I just haven't gotten around to it. The only problem is it can take up to 6 weeks to get it through the mail. If this is something people want then I'll go ahead and do it today, but it will probably be a while. If frame is holding you up on your build I could send you it for some change and then when I get the title I'd send it out and you pay the difference, whatever that is.
 
The cylinder head was off the motor when I bought the bike, so no it was not running when I got it. The bottom end of the motor was media blasted then put through a series of baths and sonic cleaning to get it spick and span. Jugs haven't been touched and need a good hone at a minimum. The head is complete minus the camshaft. I never got around to taking it apart so I'm not sure what would need to be done with it - might just need minor valve adjusting. You could do a very easy seal test and see whether or not they are okay; I just never got around to it then started parting out to fund other projects. It would come with the starter motor and wiring harness as well. Shoot me an offer on it if you're interested. I'm a motivated seller ;D
 
I'm just being lazy. I'll run by the police department tomorrow and get the VIN cleared. I have just been dreading the visit with the 5-0. Once done I can sell the titled frame or just the VIN plate. Either way doesn't matter to me. After the title is sold if the frame doesn't go to the new owner it is headed to the trash... Or free.
 
alec, I don't have any new messages from you unfortunately. Guess it didn't go through. Send me another or post it on here if you're still interested. Sorry.
 
well, I was wondering how much you want for just the cylinders, or if you would want to trade the cylinders for something?
 
I'd happily part with the cylinders for some cl175 handle bar controls. Other than that I'm not interested in separating the motor.
 
I could care less about how pretty they are. If they are not broken and fully functioning I'll take em! Assuming you're okay with that deal.
 
Well, they are complete and fully functioning, except that the right throttle body control, the mirror mount is cracked. You can't mount a mirror on that side currently. The other side is fine all around.
 
Well if you're okay with the deal I am as well. As long as the only issue is the mirror then I don't mind. If they still munt fine and do their job then I'm in.
 
You must log in or register to reply here.

DTT Light or Dark

  • DTT Light

    • Spread the Love

    Back
    Top Bottom