CB350 - Newer Coils - Bulging/Blown up?

wibblee

New Member
I've come back to my project CB350 after being absent from it for about a year. New addition on the house had taken my attention away for the last eight months, but has provided me with another garage to get back to tinkering.

Last spring when I was starting, I ordered up new coils from Mike's XS, new condenser and points. I installed everything then had to switch projects. The bike never really got to run and it sat with no battery for eight months.

Fast forward to yesterday. I put in a new battery, put it on the charger overnight. Today, I took off the gas tank to reroute my fuel lines and my one coil looked like this:

IMAG00101.jpg


It is completely bulging in the middle. The other one is fine.

Has anyone seen this before? Was there something wrong with the coil or did I do something wrong to create this? I'm assuming it's dead and I'll need a new one. Any insight at all would be greatly appreciated.

Thanks,
John
 
looks like the ignition was left on...The points that are closed allow continuous current through the coil. Not good. A coil is only powered once per 2 revolutions of the engine, for a short time. It is not made for continous power draw.

Never leave the ignition key on without the engine running, or at least the kill switch in the off position. Otherwise this happens.

Check your points too. If the coil if fried, the points for that coil may be also.
 
Thanks a million for your reply.

As soon as I read it, a crapload of light bulbs went off, and it explains the problems I had last year.

I guess I'm back to waiting for the FedEx guy again. I'm just glad to know I only fried the one. My stupidity only cost me half of what I thought. I'll check the points too later tonight.

Thanks again.
 
Back
Top Bottom