overdraft
Coast to Coast
Re: CB350 Project 'Sly'... brake disaster
well the brake rebuild didn't go so well... i put a new seal in the caliper, got a stainless brake line and bought a brand new master cylinder. i've bled the thing every way possible... vaccuum pump, injected from the bottom, even old skool open bleeder, squeeze lever, close bleeder, release... result? the brake pumps up, but never gets hard (sounds like a job for viagra!) so i took it apart... no seeping in the caliper... so either i STILL haven't got it bled properly and there's still air in there somewhere... OR maybe the master just isn't pushing enough fluid through to get the system pressurized? does anyone know if these old one pot calipers need a giant master? the one i have is off a cbr125r and is pushing a 2 pot caliper... any thoughts welcome... grrr.....
well the brake rebuild didn't go so well... i put a new seal in the caliper, got a stainless brake line and bought a brand new master cylinder. i've bled the thing every way possible... vaccuum pump, injected from the bottom, even old skool open bleeder, squeeze lever, close bleeder, release... result? the brake pumps up, but never gets hard (sounds like a job for viagra!) so i took it apart... no seeping in the caliper... so either i STILL haven't got it bled properly and there's still air in there somewhere... OR maybe the master just isn't pushing enough fluid through to get the system pressurized? does anyone know if these old one pot calipers need a giant master? the one i have is off a cbr125r and is pushing a 2 pot caliper... any thoughts welcome... grrr.....