cb350 stock head gasket with 66mm bore

sandman28

Been Around the Block
Was thinking I would have to order larger than stock head gasket, but when I took my new one from the gasket set and compared it to my bore I found that the head gasket that came in my kit actually measures 66mm on inside and does not lap over my cylinders, curious why the head gasket in this kit would be larger than 64mm stock bore and if its ok to run with my 66mm bore ?
Thanks!
 

Attachments

  • IMG_1662.jpg
    IMG_1662.jpg
    1 MB · Views: 259
The only problem I see, is when it is compressed, not all the gasket will have contact with a surface. Some of it may squeeze over into the combustion chamber, albeit very small amount. The area exposed may have some heat issues getting red hot, not having the ability to transfer heat as well.
 
didnt think about the squish factor, prolly get a 66mm head gasket from bore tech. So would that one like 68mm and squish to 66 ??
 
It would be close, there is a reason oversize gaskets are offered. To be on the safe side, you should use the oversize gasket. One less thing to worry about. My head gaskets on the mono-block motors have to be custom made from Cometic. They don't match the bore diameter and leave a small area for squish. On a mono-block, the cylinders are part of the upper crankcase. If you mill the surface of the block, the only way to compensate is to have a thicker head gasket.
A separate block, you can just add a base gasket to bring the deck height back to spec.
 
Back
Top Bottom