CL 450 bottom end questions

  • Thread starter Thread starter MB
  • Start date Start date

MB

Coast to Coast
So, what started as a simple "replace shift drum forks" repair has ended in rebuilding gear shafts, and replacing the bottom cases due to a busted bearing in the case..... It was easy to split the cases and work on the transmission from the bottom with the side covers off, was glad I didn't have to disassemble the top end to get at it.
So I have a question I'm probably gonna be lampooned for but here I go......The only way I have learned is by asking questions and making mistakes anyways
So now I'm replacing the top of the lower cases. So I have to take out the crank as well. Is it possible to continue working in the way I have been, engine upside down without removing the top end? Can I get the crank out with rods and pistons attached? I can forsee there being a problem getting them back in from this unusual angle but if I can attempt this repair from this position it will really save me a bunch of time as I have not been in the 450's top end before.
Thank you in advance, be kind.
 
I'm no expert, but I'm doing a 450 build myself and have taken my engine apart.

I'd like to start by saying if you're doing all of this, removing the head is not a big deal. It's actually pretty easy, and the hardest part of reassembling the top end will be the setting the cam timing and putting on the cam chain. It may be even worth it for the opportunity to take a look at the combustion cambers and top of the pistons.

Here's my two cents:
- I guess you could rotate the crankshaft until you see the master link, then break that apart.
- Tie a long piece of wire to each side of the chain just in case it goes into the head and you can't get it out. This is paranoid and you probably won't have to worry about this even if you skip this step.
- Remove the crank bearings, then pull the crankshaft out.

Possible consequences:
- If you leave the rods attached to the crank and pull the piston's out too, I imagine you're going to have a very difficult time trying to get the pistons back in. I'm not sure how you would compress the rings from the bottom side with what room you have to work with. Or perhaps I'm overestimating the difficulty of doing this.

Can you leave the pistons in the cylinder?
 
You can leave the crank (with rods attached) along with the transmission in the lower case but this pistons will have to come off before you can get the top case off. I can't remember about the clutch or not, but you might as well take that off, too. It's pretty easy anyway.
 
Yeah, you know what, I reckon I'll take more time an make more trouble by half-assing it. I'm gonna disassemble the entire engine. I guess I wanna see the different valve mechanism anyhow. Sonreir, feel like, ahem, a trip to Brooklyn anytime soon to lend a busy a hand? Ha
 
Back
Top Bottom