Has anyone fabbed a top motor mount for a HONDA CB to XL swap?

[BERMUDACB]

Hello,

I'm hoping someone else has swapped out a CB single cylinder motor with an XL single cylinder motor and had tabbed a top motor mount?
It doesn't seem particularly hard to do but just checking to see if someone else had done this.....

 

[Hurco550]

If you read the gas axe thread on the chop cult forum, it uses the stock 360 top mount, just spaced over a bit for sprocket alignment iirc

Sent from my SM-G920V using Tapatalk

 

[iatethepeach]

Hurco, do you think that would apply to the smaller-displacement Hondas? I think Bermuda is talking about mounting a 185/200 engine in a 100/125 frame.

 

[Hurco550]

I'm sorry, I completely miss read that and was thinking of another build thread with a 600r motor in a 360 frame.

Thanks for the catch on that one.

Sent from my SM-G920V using Tapatalk