Hi from Grass Valley, CA

[BFT Boyle]

Hey folks!

Figured I would try out one of these forums since I use them a lot for tips and inspiration.

I am mostly going to be covering my current and up coming metric builds, my first baby is the family BSA. I once held the AMA MVG-650 Land Speed Record and am pursuing it again, but that's a whole different thread.

My current project is a 74' CB125S that I am breathing life back into.

I guess that is it for now! I'll try to figure this site out and start a build thread somewhere.

 

[Hurco550]

awesome. welcome to the madness. looking forward to watching your projects

 

[gordo2472003]

Hey bud. Looks like a fun little project. I'm just down the road from you at the Base. Can't wait to see this bike zipping around Hwy 20.


Sent from my iPhone using Tapatalk

 

[DohcBikes]

Lots of potential here. Welcome to DTT.

Have you considered an engine swap on the 125? Lots of engines will bolt right in (with a few mods here and there), some up to 230cc's

 

[BFT Boyle]

Hey bud. Looks like a fun little project. I'm just down the road from you at the Base. Can't wait to see this bike zipping around Hwy 20.


Sent from my iPhone using Tapatalk

Hey man, that's awesome! I've got a buddy living in Smartsville actually. Yeah I'm looking forward to hitting up Chuck Yeager road and going through the Camp Far West area. I was getting lost on my Kawi600 a couple years back and discovered that route. Lots of great riding through these hills....

Lots of potential here. Welcome to DTT.

Have you considered an engine swap on the 125? Lots of engines will bolt right in (with a few mods here and there), some up to 230cc's

Hey DOHC,

I have done that after reading the possibilities on here, but I'm already pretty invested in the 125 engine...I started this forum a little late.

Engine is just about finished. Basically everything above the crank is "new" via Ebay (Chinese knock-off 125cc) Last thing to do is modify the new cam. All the Chinese stuff is for a CDI setup, so it didn't have that extended nose for the points. I've got a nose adapter machined and installed into the new cam, but I need to get that little roll-pin that controls the points clocked in.

 

[coyote13]

You go from LSR to a CB125?


Just the right amount of crazy to fit in around here... welcome!

 

[DohcBikes]

plaid, heavy frames, and a taco holder for a hat, he's a shoe in

 

[gordo2472003]

Yea man chuck Yeager road is my favorite.


Sent from my iPhone using Tapatalk