buckeyebike
Over 1,000 Posts
Just ran across this locally- thought maybe I could use it on one of my bikes. Didn't realize until I saw it that it was much too large for my smaller CBs. Bought it with the intent of listing it on ebay but figured I'd give you all a chance at it first. The little information I can find, other than it not being a readily available piece, is that it was likely used on older sport bikes.
The carbon is in excellent shape with some dulling of the clearcoat- but it is uniform, so may not have been overly glossy to start with. The stainless is nearly perfect as is the exhaust tip. The sleeve end that slides inside or over the header has been muffed with. Looks like the guy tried to install it over a smaller diameter header and tried to crimp it down. I have straightened it some but plan on finding a pipe of the correct diameter to slide into it and pound it out more.
The ID of the fitting is 2 1/4 and the OD is 2 3/8.
Looks like Kerker carbon silencers run in the mid $400 range.
Make me an offer I can't refuse!
The carbon is in excellent shape with some dulling of the clearcoat- but it is uniform, so may not have been overly glossy to start with. The stainless is nearly perfect as is the exhaust tip. The sleeve end that slides inside or over the header has been muffed with. Looks like the guy tried to install it over a smaller diameter header and tried to crimp it down. I have straightened it some but plan on finding a pipe of the correct diameter to slide into it and pound it out more.
The ID of the fitting is 2 1/4 and the OD is 2 3/8.
Looks like Kerker carbon silencers run in the mid $400 range.
Make me an offer I can't refuse!
