KZ400 Engine removal question

theracedude

New Member
I am rebuilding a 76 KZ400. My wife and i pulled the engine out of the right side and it was a bitch..(the removal process, not the wife).

So whats the trick so i dont fu*k up my paint on the install? thanks for the help
 
There is a good tuturiol in the $50 mod thread about using some foam pipe insulation. Can't help with squeezing it between the rails, but at least it won't scratch the paint.

and if the frame is empty (suspension, tires, etc) you can actually lay the motor on it's side and put the frame over top of it
 
theracedude said:
I am rebuilding a 76 KZ400. My wife and i pulled the engine out of the right side and it was a bitch..(the removal process, not the wife).

So whats the trick so i dont fu*k up my paint on the install? thanks for the help

I'm rebuilding a 1976 KZ400 as well and I agree. It is a complete and utter pain to pull the engine. But like Big R said, the best way is to probably lay the engine on its side, put the foam insulation on the areas of the frame close to the engine and then fit the frame onto the engine instead of fitting the engine into the frame. I just finished rebuilding the engine and it is all painted but I still have to finish the frame and paint it. Putting the engine back into the frame is probably the part of this build I am most dreading.
 
Lay the engine on its side and lower the frame onto it. This assumes that the forks and wheels are off the frame, otherwise that's a little awkward.

Dish towels and packing tape will protect the frame, pipe insulation seems like it would cut down on your clearance a bit.
 
dielectric said:
Dish towels and packing tape will protect the frame, pipe insulation seems like it would cut down on your clearance a bit.

Somebody mentioned using an old garden hose (instead of the foam) and cutting a slit down the side. Should help with the clearance
 
for the really tight places, a layer or two of painters tape does the trick.
 
thanks for the help guys. i am new to the site and i guess i need to click the little box that lets me know when i get a reply....so anyways i got it back in by using a shoe horn some grease and using the "F" word alot. i learn things the hard way! ;)
 
Back
Top Bottom