kz750 dna springer

[Schmeck750]

Anyone put a dna springer front end on there kz750 twin?
I need bearings with a smaller inside diameter. My top bearing is 12 width, 48 od,30 ID and the bottom is 16 width, 52 OD and 30 ID. I removed my stock front end and bearings already. It has flat bearings? I'm used to the angled bearings in newer fork necks.
Anyone who has experience with this feel free to chime in. Advice is appreciated.

 

[RedBullEnema]

Unfortunately their web site doesnt seem too keen on providing any actual specs, but do you know what the springer stem size is?

Start with the AllBalls steering bearing size chart: http://www.allballsracing.com/media/productshowcase/AllBallsSteering%20Bearing%20Size%20Chart.pdf

As Im sure you already know, maintain your current width and OD if you can and just find the ID that you need..often it seems that you can get the right ID and OD but not the orig width, but I think it would be okay to sway a couple mm's if you absolutely have to.

Good luck!

 

[Schmeck750]

Yeah that's what I have found . Width seems to be off by a mm but I don't think it will make that big of a difference . I know what I need just waiting on cash to fly into my back pocket . Always flies out but never in . ;D