If you don't want to push it back, then shim the rubber with washers.
That's common when someone has tried to blow out a minor dent with airline. You may get lucky with a 2" wide strap or several narrower ones to pull sides back in. You will have to go further than width you need as there will be quite a lot of spring backdjsmiles said:Well how in the hell am I going to squeeze it back together safely and evenly? I've never heard of this happening.
What if I wrap a wratcheting strap around it, tighten it up and let it sit overnight?
Is it possible to break welds or crack it?
On a positive note I got the bike running for a couple minutes. I had to play with the throttle to keep it running. Tomorrow night I'll start adjusting points and carb screws and whatever other YouTube videos I can watch.
Sent from my iPhone using DO THE TON
djsmiles said:
Can't remember if there are 110 or 115 but either will get it running and rev to at least 7~8K. You'll have to do plug chop for high rpm , shorter the exhaust, more secondary main jet you need. Are they stock bars? Looks good all silver.djsmiles said:Maybe I'll mess with that this coming winter. Hey PJ, now that I'm finally at the point to start adjusting the carbs that you rebuilt for me, I don't know if you remember but do you think the right jets are in it now for my set up or might I have to change them,?
Sent from my iPhone using DO THE TON
djsmiles said:I figured out that I'm missing the cylinder head cover breather tube. Not sure if it is related. Could someone tell me what size tubing I need and where does the other end go?
Sent from my iPhone using DO THE TON
djsmiles said:So the idler adjuster screw is all the way out and it's running to high rpm's.
It also pops every once in a while. not as loud as a backfire but a big pop.