Hey everyone,
A few months back I did an introduction thread and decided I better get a thread going in here so that I can track the progress of my build, share it, and ask all of you a ton of questions. I have some mechanical knowledge from years of working on my motocross bikes but this will be my first foray into the street side of things.
My project is a 1975 Yamaha XS 500B. I know a few on here have built a few XS 500s in the past and I hope they will chime in when I get stuck or just give overall advice. The bike was running when I bought it but did not have a title. Therefore I picked it up for $300.
I have torn the bike down completely and have taken a ton of pictures so that I will remember how things go.
Here is the bike when I initially got it home:
Tear Down:
Polishing some covers as well as hubs(180/320/400/600 grit sandpaper then buffing wheel):
Before:
After:
Hub before:
In progress:
Finally finished:
A few months back I did an introduction thread and decided I better get a thread going in here so that I can track the progress of my build, share it, and ask all of you a ton of questions. I have some mechanical knowledge from years of working on my motocross bikes but this will be my first foray into the street side of things.
My project is a 1975 Yamaha XS 500B. I know a few on here have built a few XS 500s in the past and I hope they will chime in when I get stuck or just give overall advice. The bike was running when I bought it but did not have a title. Therefore I picked it up for $300.
I have torn the bike down completely and have taken a ton of pictures so that I will remember how things go.
Here is the bike when I initially got it home:
Tear Down:
Polishing some covers as well as hubs(180/320/400/600 grit sandpaper then buffing wheel):
Before:
After:
Hub before:
In progress:
Finally finished: