Alright folks, I've been lurking around for a while, using the site as an encyclopedia of knowledge and a source of inspiration. Now I figure I'll introduce myself. I picked up a 1980 CB650C about a year ago. Didn't pay anything for it (literally nothing) and decided I want to turn it into a cafe racer. Yup, not everyone's first choice for a build like that, but since it was free and with a little imagination and work, it'll be everything I want.
Haven't done a whole lot with the bike since I brought it home. Made sure it actually started and would run before I went any further. The bike didn't have a gas tank or seat, so an inaugural ride was out of the question, but an auxiliary fuel tank connected to the bike proved what I needed to know. It started, and ran, but not very well. Clutch needs work, carbs needed cleaned, and after testing the compression, rings or valves need some love. Actually the rings may be alright, but since I dropped the engine out of the frame and plan on going through the top end anyways, might as well replace them while I'm in there. No clue if I had the all too common oil leak or not, the bike was pretty dirty from sitting next to a barn for a while and my first stop was to power wash the crud off it so I could see what I was working with. Plus I pulled the motor because I can. I'm going to hit it with some paint, make sure everything is how it should be, and it's almost winter, so I won't be riding for about 6 months anyways.
The frame won't be too bad. Need to fab up a tail loop and cut/straighten where the frame dips for the seat. Looking at clubmans for the bars, new speedo/tach, just the general stuff to freshen it up. Have a few parts at the house already (DCC Seat, new gas tank, and new carbs). Speaking of the carbs, Murray is awesome. Ordered a set of intakes with Mikuni carbs from him. Obviously I can't speak to how well they work yet, but the intakes look great and Murray was great to work with. I'll post some pics and let everyone know how things shake out with them as soon as I start getting things back together.
Well, I look forward to the wealth of knowledge that I'm certain I will continue to acquire from all the fine folks on the site.
Haven't done a whole lot with the bike since I brought it home. Made sure it actually started and would run before I went any further. The bike didn't have a gas tank or seat, so an inaugural ride was out of the question, but an auxiliary fuel tank connected to the bike proved what I needed to know. It started, and ran, but not very well. Clutch needs work, carbs needed cleaned, and after testing the compression, rings or valves need some love. Actually the rings may be alright, but since I dropped the engine out of the frame and plan on going through the top end anyways, might as well replace them while I'm in there. No clue if I had the all too common oil leak or not, the bike was pretty dirty from sitting next to a barn for a while and my first stop was to power wash the crud off it so I could see what I was working with. Plus I pulled the motor because I can. I'm going to hit it with some paint, make sure everything is how it should be, and it's almost winter, so I won't be riding for about 6 months anyways.
The frame won't be too bad. Need to fab up a tail loop and cut/straighten where the frame dips for the seat. Looking at clubmans for the bars, new speedo/tach, just the general stuff to freshen it up. Have a few parts at the house already (DCC Seat, new gas tank, and new carbs). Speaking of the carbs, Murray is awesome. Ordered a set of intakes with Mikuni carbs from him. Obviously I can't speak to how well they work yet, but the intakes look great and Murray was great to work with. I'll post some pics and let everyone know how things shake out with them as soon as I start getting things back together.
Well, I look forward to the wealth of knowledge that I'm certain I will continue to acquire from all the fine folks on the site.