New LED lights, not flashing, only staying solid!

CupidsDeathDay

CupidsDeathDay

Been Around the Block
I changed my old lights over to LED turn signals but they only light up. They don't seem to want to flash when i use my turn signal. Could this be a resistance issue with the signal regulator(Nippo)? How is this fixed?

BTW, they were working fine with the old turn signals. I even tried a different signal regulator with no change and i know they both worked before i changed the turn signals to LED.
 
Get an electronic flasher relay for LEDs from your local auto parts store for <$10. It will likely have three prongs and the third one will need to go to ground.

Also what kind of bike do you have? Does it have a single turn signal indicator? If so, you will have to mod the wiring for that or they won't work. In the meantime, you can just remove the indicator bulb so it doesn't mess things up.
 
I had the same problem and found out I was putting in the load equalizers in wrong.
you will need them and make sure you put them one end to positive and one to negative.
I thought you put them inline on the positive side as soon as I put them like they should be problem solved.
I can tell you on mine a led relay alone did not work for me.
 
FL32 or EP37 from Autozone etc. will work. If you are installing resistors you are negating the major benefit of switching to LEDs.
 
Flugtechnik said:
Does it have a single turn signal indicator? If so, you will have to mod the wiring for that or they won't work. In the meantime, you can just remove the indicator bulb so it doesn't mess things up.
Click to expand...

+1
 
Btw it originally had a dual indicator light set up but it's taken out of the equation as I don't use the indicator lights.
 
Hey would something like this work?

http://www.ebay.com/itm/191131325701

It says it's made for lower wattage LED indicators but it doesn't specify the load rate..


Sent from my iPhone using Tapatalk
 
It's EBAY, anything is possible.

If it does, let me know because mine is currently held on with zip ties.
 
If you go to superbrightleds.com you can get one shipped to your door for about $12. And I know it'll will work because I use them on all my bikes and my Stepside ;)
 
Holy crap! I forgot about that site! :o I just ordered a no load relay so we will see how that goes! Thanks man!


Sent from my iPhone using Tapatalk
 
http://www.superbrightleds.com/moreinfo/flashers-load-resistors/fl3-red-led-bulb-electronic-flasher/780/834/

Hey guys is this the right flasher relay to be able to use LED turn signals?
 
I ended up using this one on mine, but mine only uses a 2-terminal connector! So yours might differ.

http://www.superbrightleds.com/moreinfo/flashers-load-resistors/cf12anl-01-led-bulb-electronic-flasher/781/835/

Works Great, and its easy/inexpensive to replace. I bought like 3 just in case one wasn't working or if one goes out on me.
 
Just make sure that the terminals match. They have info on which terminals do what! So make sure they match your schematics for the turn signal relay!
 
surfish95747 said:
Okay, so depending on how many pins my current flasher has, is how many I need to get on the new one?
Click to expand...
Not necessarily. What bike is it going on, and what type (single or dual) dash indicator do you have?
The one you linked to will work in any configuration. You just may or may not end up not using the "P" terminal ;)
 
You must log in or register to reply here.

DTT Light or Dark

  • DTT Light

    • Spread the Love

    Back
    Top Bottom