Before I write this next post, I want to apologize for getting a bit sappy. But here goes. I did not expect, nor did I think it was possible, for this bike to spring to life. I didn't get much of a chance to ride her before the tear down, which was probably stupid but it's how you learn. I had everything at my finger tips to mock up a complete-looking bike, yet not at all functional yet. You will see in the photos below what I'm referring to, but this is the first time in my life when we have built something from the ground up, exactly how I want it - and I say "we" because this forum is building this bike. All of you as a collective are building this through my eyes, and I'm much appreciative. I can't count the number of entire threads I have read only thinking what I would do if I had the mechanical and fabrication skills as most of you do. But here I am looking at this bike, sitting there somewhat anthropomorphic looking back at me with her 5-3/4" Bates lamp.
Sorry for the sidebar, but this project was the last thing I thought I would be doing a few years ago, and I can't believe I've even gotten this far. I can't wait to hear her purr.
On to the updates. Here is how she sat this morning:
And here is how she sat a few hours later. The nuts and bot are not tight as this is just a test fit, but so far everything is coming together wonderfully!
So here is my "need" list, because we all have them
- Front brake switch (i'm going to drill a hole through the DCC perch and squeeze an ebay switch in there)
- Electronic ignition (full system, with advancer from Probe Engineering - this is pricey and what I'm saving up for now)
- Custom harness from Sonreir (I'm gathering all my electrical components and will send everything out to him to wire it up)
- Custom 2-1 exhaust (I have a local guy who's going to fab me up a 2-1 rt. side exit by the rear set)
- 1.9" Gauges (hope to get these "Santa"
- Motobits Rear sets (also from Santa)
Thanks for watching!