Post a pic of your latest purchase

I made a tube bender out of a ford 9 inch and a porta power with a chunk of chain and left it at the garage I was working at, worked great fro small exhaust to 1.5"

You might can find dies on eBay from old shops that could be re purposed:

http://www.ebay.com/itm/Parker-Pipe-Tube-Bender-Die-Radius-Block-5x1-/121910971373?hash=item1c6275cbed:g:cSAAAOSwWTRW1e-j

s-l1600.jpg
 
New ignition switch because some jackwagon thought my bike should be theirs and the screwdriver and makeshift key they made wouldn't work. My favorite was that they tried to hotwire it by shorting two of the power wires together. :o

25079466723_f9d610fc22_z.jpg
 
No pics yet, but just ordered a 5 axis cnc retrofit kit for one of my knee mills. Going to see how I like it, and if I do, retrofit the rest of them.
 
Going to be about three weeks before it shows up. Need to get a ball screw to run the spindle off if as well. Have a friend with one on his old Bridgeport Boss he uses for cutting gears, and he loves it. Hopefully I feel the same.
 
J-Rod10 said:
Nice!

Getting to be quite a lot of lathe guys on here.
I've noticed that. I did it in the Navy and for a few years after. Never thought I'd do it again, but 20 years later and it comes full circle.
 
Back
Top Bottom