Project Betty 1976 Honda CB360t

§neakyGit

New Member
Hola DTT,

I was directed to this site by a friend (Swissguy on here).

Anyhow. I recently picked up a 1976 honda cb360t with a parts bike for a whopping $500. 2 engines, 2 frames, 2 carbs, 2 seats, 2 gas tanks to get myself started. One engine worked before it was pulled off the frame, the other engine is unknown. Tanks are a little rusty insides, not terribly.

Im a little tired at the moment I will do some full pics (on my crappy iPhone) tomorrow.

Also, If anyone is looking for stock CB parts, I have a ton I wont be needing. Just leave me a message or a post here.


The plan is to cafe out the bike, put in some knee dents, paint it a flat drab army green (think 1940s era military vehicles). Put some pin up girl decals on it maybe. I want to strip down the wiring and run it on a capacitor. Maybe some pods because I like how they look.

8)
 
welcome sir!!!
Yet another cb360. Lots of info on them around here!!

Pics are much appreciated as with any forum.
If you would like to part ways with one of your tanks let me know. I discovered an "incident" last night with mine in the garage and will probably need a replacement.

good luck with the build!
 
Ill let you know. If getting my knee dents in the tank goes well and I dont fuck it up I can sell it to ya. I will probably get to hammering the tank in the next week or two. Looking around for an air compressor to help with the clean up process, Any suggestions?
 
I did some knee dents on mine as well prior to it falling 6ft to the ground :'(

If i were to do it again I would use a nylon hammer not a ballpeen. Also to get the dents more even and cut down on the amount of body filler needed, I would make a sac out of canvas filled with buckshot or something like sand maybe and hit that. I've never used this technique but from what i have read it allows for less finish work.

you can see the results that I got here (notice the filler I had to use to get it "somewhat" smooth) http://www.dotheton.com/forum/index.php?topic=33089.msg356721#msg356721

Good luck and why not start a build thread of your own?
Even though I've definately started slacking on mine!
 
Back
Top Bottom