Replacing the honda cb400f silencer with a suzuki 850 gs 4in1 (Marshall)

[mogalike]

Hi does anyone know if the 4 in 1 exhaust system from a Suzuki 850 gs (make Marshall) can fit my CB400F?

 

[Tune-A-Fish]

It sure will!! All you need is a grinder, cut off wheel, tig welder and some balls

 

[J-Rod10]

Tune pretty well lined you out there.

If you are looking for a bolt on solution for a new exhaust. But a CB400F exhaust. Best looking part of that bike anyhow.

 

[mogalike]

The one thats on is falling apart and the only one I can get my hands on is this used Marshall. I'm picking it up tomorrow, so let's hope I can get it on. Also if I did succeed in getting on, I'm worried about the performance of the bike if the replacement is over dimensional?


Sent from my iPhone using Tapatalk

 

[J-Rod10]

That exhaust will be absolutely no where near fitting the 400F. The outside two pipes are likely wider than the 400F motor. You're wasting your money.

 

[J-Rod10]

There are 20+ 400F pipes on eBay.

http://m.ebay.com/itm/1976-76-Honda-CB-400-F-head-pipe-exhaust-4-into-1-/121857554053?nav=SEARCH

 

[DohcBikes]

I'm assuming from a conjugation or two that you aren't in the U.S.

No matter what country you're in, that big ol 850 header ain't gonna fit your lil ol 400. Like Jrod says don't waste the money man.

 

[J-Rod10]

This has to be a troll post.

 

[Grazz256]

It sure will!! All you need is a grinder, cut off wheel, tig welder and some balls

lmao thank you, that made cry a bit