crazypj
Split personality, I fake being smart
AlphaDogChoppers said:Don't make that assumption. Rent a cylinder leak-down tester and determine where you are losing compression. Dollars to doughnuts it's your valves.
The thing about lapping valves is that there is a limit to how wide the valve to seat contact area is. (The service manual is quite specific on those limits.) If you lap them too much, your valve job will not last. You should only lap just enough to get them to seal. Too many guys lap the valves WAAAY too much.
After doing a little research, I realized that the CX500 already has a pretty high compression ratio, and one should not attempt to raise the compression. The real key to performance on this engine is Murray's carbs. (CXMAN) They are easy to install and adds 20% to the horsepower. The one I did dynoed at 59 hp at the rear wheel. It would easily lift the front wheel in the air in second gear, even if you didn't intend to. Power starts coming on at around 2,500 RPM and pulls like a freight train right on past redline. With the stock carbs, it didn't start making good power until 5,500 RPM.
That's pretty impressive for basically a stock CX 500. Bike was always designed to be a revver not a plodder. Keeping it over 5,000rpm make cam chain tensioners last more than 17,000 miles 8)
Could re-work the hell out of one for the 500 pushrod class at Bonneville
as long as cranking compression doesn't go over 225psi it will run on 95 octane pump gas