scott_jangers
Active Member
Hi all,
I'm getting smoke coming out of the breather on a CL350 which I purchased recently. I am I in the process of jetting the carbs and went for a 30 mile trip to test out the current setup/throttle positions. It was the first time I have ridden the bike. It has VM28 carbs with velocity stacks and the mufflers have been replaced with black 12" shorty ones. I did a cold compression test when I first got the bike home and both cylinders were on 175psi. Ignition timing has been done and oil level appeared okay.
I am all the way out on the mixture screws and at the lowest clip on the needle. The bike is a little rich but using a colortune it has a blue tinge. A smaller pilot and leaner needle is on its way.
It has a bit of hesitation in low revs and transitioning at 3/4 throttle maybe.
The bike ran fine until I got home and noticed white smoke coming from the breather, puffing out in time with the idling. It was an usually hot morning compared to the last few days.
I would like to continue jetting the carbs but I'm now a little scared or cautious to ride the bike before doing a few further checks. Can you give me some tips on what I should be doing next to work out the cause of the smoke?
My thoughts are to check oil is getting to the head/valvetrain and maybe check the compression again? Should I ride it again to see if it still occurs?
Thanks,
Scott.
I'm getting smoke coming out of the breather on a CL350 which I purchased recently. I am I in the process of jetting the carbs and went for a 30 mile trip to test out the current setup/throttle positions. It was the first time I have ridden the bike. It has VM28 carbs with velocity stacks and the mufflers have been replaced with black 12" shorty ones. I did a cold compression test when I first got the bike home and both cylinders were on 175psi. Ignition timing has been done and oil level appeared okay.
I am all the way out on the mixture screws and at the lowest clip on the needle. The bike is a little rich but using a colortune it has a blue tinge. A smaller pilot and leaner needle is on its way.
It has a bit of hesitation in low revs and transitioning at 3/4 throttle maybe.
The bike ran fine until I got home and noticed white smoke coming from the breather, puffing out in time with the idling. It was an usually hot morning compared to the last few days.
I would like to continue jetting the carbs but I'm now a little scared or cautious to ride the bike before doing a few further checks. Can you give me some tips on what I should be doing next to work out the cause of the smoke?
My thoughts are to check oil is getting to the head/valvetrain and maybe check the compression again? Should I ride it again to see if it still occurs?
Thanks,
Scott.