TZ wheel set perfect for anyone with an RD. Alloy rims

sunnamp33

Been Around the Block
I am selling my wheel set I was going to use on my bike. Just lace up the rear and ride them as they are or polish them up and get new spokes. Anyone looking to run dual discs this is the set up for you. The drum is from a rd350. The front wheel is a 1.85 x 18 DID and the rear is a 2.15 x 18 DID. $250 and they are yours. If you don't like the price send me an offer. Than you for your time.
 

Attachments

  • 20120304_200051-1.jpg
    20120304_200051-1.jpg
    313.3 KB · Views: 179
  • 20120304_200123-1.jpg
    20120304_200123-1.jpg
    136.4 KB · Views: 168
  • 20120304_200105-1.jpg
    20120304_200105-1.jpg
    157 KB · Views: 175
Rims appear to be TZ C-G. Rear hub is RD/R5/DS7 street bike. What markings are cast into that front hub? It looks like a TZ which of course all came with a single disk on the twins. It's probably 1H3 or something similar.
 
It has 1H3 cast into the hub. You can mount a rotor to both sides of the hub. Or just one side. Your choice.
 
1H3 was the model code for 1975 TZ350C. The same hub was used on all 250 and 350 from then until 1979. 1980 hub is 3G3 IIRC. Correct that it can take two disks. RD400, XS650, TZ250,350 and 750 disks share the same bolt pattern.

TZ250 and 350 used a single disk - that was all they needed to slow down from 150 per, though some riders fitted a second disk. In my experience, one was enough and two were a pain and hard to modulate. I ran double disks on a TZ250 with TZ750 reed valve top end. I wouldn't do that again unless the frame was improved as well as the forks.
 
Teazer, I am in awe of your knowledge... And if I didn't have a baby on the way, I'd be all over these suckers.
 
Thanks but it's no big trick. I had a couple or three TZs in the past and have one on the bench right now.

Nice rims but the front hub is too wide for s stock RD front end IIRC. I tried to squeeze one into a and RD once and it was easier to use an RD/XS/TX hub with an XS650 (TZ750 look a like) disk and carrier.

Those rear brakes can be made to look pretty spiffy if you change them to cable operation and add some air scoops or just a pile of holes and they are perfectly adequate on the street or the track.

Before I forget though, that rear rim is not a good match to that rear hub. The rim is drilled to suit a small disc type hub, so the spoke angles are probably all wrong. You may be able to tweak them to make it work.
 
Back
Top Bottom