The part with the square hole machined in to it goes to the outside of the pivot. That situates on the stock rod Thay runs through the frame, and it is drilled and tapped for the stock bolt to secure it.
I just bought a set from you off instagram. Wish I had seen them on here first! Haha. Anyway I could order just linkage and pivots for my '74 cb350f? I'll need to measure the length needed for the linkage since I'm mounting them in a position different than your bolt on kit.
Hey J-Rod, I tried making the rear sets work but I had to sacrifice the positioning. Is there any way I can return these and get a refund? Thank you for your time
Have been busy with a job in my machine shop for the last couple weeks, finally wrapped it up. To those who have shot me a PM asking about these, they are available again.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.