Swing arms invariably need shims. Very often, the frame will seem too wide (or too narrow) for the arm, but will be drawn together by the swing arm pivot bolt. The shims are needed because the span of the internal bushings has to be slightly wider than the span of the swingarm (with outside bushings) so it does not get clamped to the frame when the pivot bolt is tightened. The shims are needed to take up whatever slack is left. These shims are invariably not shown on the parts exploded view even though they are invariably included in the factory assembly. You should shim to zero lash. I trial assemble with light oil or WD40 to get the fit right (takes a couple of trial and errors) and then final assemble with wheel bearing grease. This will result in a VERY tight fit but will almost immediately loosen up to perfect after a few miles. The arm should just fall of its own weight when correct. Looser than that will be needlessly sloppy.