If EVERYTHING is stock those carbs should not need to run on choke. That and the2 turns out comment suggests that the pilot jets are still partly blocked or the air passages to them are blocked. It's also possible that there's an air leak somewhere - usual culprit is the rubber carb holder where it bolts to the head or has tiny cracks in it. You mention that the rubbers are new and done up tight. That suggests maybe too tight and they have bowed.
Let's try something different. Does that bike have stubs for vacuum synching the carbs? If it does, are they capped off ?
OK, so remove the carbs and get an expandable pipe plug from your local hardware store. They look like a fat rubber doughnut with washers either side and a bolt through it. Insert that into the intake rubber and expand it enough to get it to seal. You can slather it with petroleum jelly to help it seal if necessary.
Next grab a length of tube and slip it over the synch pipe/connector/adapter and add air pressure - you can blow into it. That's all it needs. make sure the valve is closed though.
With your spare hand paint a mix of soapy water around the rubber where it meets the head and as you blow into that tube, watch for air bubbles in the soapy water.
It's just much easier to find a leak that way. That's how you find leaks in gas pipes at home too.
Another tool you could make up is a plug the same size as the spigot on your carb. Drill and tap that to take a tire valve and use a pump to apply pressure. If you have a Motion Pro leak down tester, you already have both of those tools plus a small hand pump.