YSR250

[Rat_ranger]

I decided the caliper bracket was too big, so this is v2.

 

[Rat_ranger]

Caliper bracket is ready for deburr and finishing. I also finally finished turning the HF 4 drawer cart into my new weld cart. Because I shortened it 6" I had to lose the bottom drawer to fit the tig chiller.

 

[irk miller]

Man, I need something like that for my welders.

 

[Rat_ranger]

Man, I need something like that for my welders.

There's a couple places selling bolt on kits to do similar. Other than the wheels I had everything around as scrap, so I went the cheap DIY way.

 

[Rat_ranger]

Getting close to coming off the weld table.

 

[Rat_ranger]

Progress on adapting the gsxr rear seats.

 

[Rat_ranger]

Working on the exhaust. I think I'm going to cut the inlet side off and modify it to fit directly to 1.5" tube. It'll take about 2" off the length. I'd prefer not to shorten the can itself, I leave for work early.

 

[Rat_ranger]

Muffler modified

 

[Rat_ranger]

Had to take it to the tag agency to finish the title process. They have to physically verify the VIN matches the paperwork.

But now that that is done I can finish a little fab work and tear it down to get the frame off to powder.